Yunku Industrial Safety

Wear a safety harness before using a smart safety harness, and check the quality of the safety harness to ensure safe use. Observe whether the nylon belt has broken wires and obvious scratches, whether the metal hook has visible cracks, and whether the hook locking device is intact and available.

Put on the safety harness correctly: Fasten the chest strap of the safety harness first, then tighten, and the waist buckle assembly must be tightly fastened. Finally, fasten the leg belt of the safety harness. When you fasten the leg belt, it should be kept in a moderate state of tightness. Then wear a smart safety device, which can improve the safety of the operators.

Hang the safety harness in the appropriate position: When hanging the safety harness, it is necessary to use a high hanging low using method, and to prevent swing, collision, avoid sharp substances, and do not contact the open flame. After choosing a place to hang, make sure the metal latch is locked. If it is not worn correctly, the device will issue an alarm to correct it in time.

Attach the hook and ring of the smart safety harness to the tether point firmly: When working at height, the hook and ring of the safety harness need to be attached to the tether point firmly. The rope can not be knotted, and can not move the hook and ring at will, so as not to cause danger. When there is any improper operation, it should be corrected in time to avoid unnecessary safety accidents.